imgNeilJones

PHONE 814-763-2769 - FAX 814-763-2970 - EMAIL njones@mdvl.net
17217 Brookhouser Road, Saegertown PA 16433
 


THREADED NECK SIZING DIE

USED IN A CONVENTIONAL RELOADING PRESS, THIS STANDARD 7/8-14 THREADED NECK SIZING DIE HAS BECOME ONE OF THE MOST VERSITLE PRODUCTS IN OUR ENTIRE LINE. THE DIE USES INTERCHANGEABLE HARDENED STEEL BUSHINGS, AND WITH THE PROPER SIZE BUSHINGS, IT WILL HANDLE VIRITUALLY ALL CARTRIDGES HAVING THE SAME HEAD DIAMETER.

IF POSSIBLE, PLEASE SEND US 3 FIRED CASES WHEN ORDERING. THIS WILL INSURE THE PROPER BUSHING SIZE. 		dies2
   
     
  7/8 x 14 Neck Sizing Die w/ De-Cap Punch 120.00
  7/8 x 14 Full Length Sizing Die (with De-Cap Punch) 200.00
  1 - 14 Full Length Die - Required for cartridges over .512 dia. 245.00
  Adaptor for 1 - 14 Die 20.00
  Expansion Mandrel 15.00
  7/8 x 14 Threaded Expansion Mandrel Body 20.00
  Extra De-Cap Punch for Threaded Die
(Bushing not included in Sizing Die)
12.00

order

THREADED SEATING DIE

WE BELIEVE THIS DIE TO BE THE MOST ACCURATE SEATING DIE AVAILABLE TODAY FOR USE IN THE STANDARD 7/8-14 RELOADING PRESS. MAXIMUM ALIGNMENT IS ACHIEVED BY A DIRECT IN-LINE ARRANGEMENT FROM THE NECK OF THE CASE TO THE SEATING PUNCH. THE ADJUSTMENT SCREW IS CALIBRATED AND SEATING DEPTH CAN BE EASILY CHANGED BY AS LITTLE AS .001" AT A TIME.

7/8 x 14 Bullet Seating Die (with 1 #5 Bushing) 145.00

order

DIE BUSHINGS

  Shoulder Bushing #2 13.00
  Special Shoulder Bushing #2 15.00
  Seating Guide Bushing #5 10.00
  *All 17 Caliber and those over 30 Caliber additional cost applies 2.00
  50 Caliber Neck Sizing Bushing 20.00
  50 Caliber  Seating Bushing 15.00

order